I ran into a UE96 error when running my block.
- Hardware and Systems
The cause for this error is usually due to your machine running out of memory as it is running the block.
There are a few fixes we can suggest when this occurs:
- If it happened when you were using a meshing block, try increasing the tolerance of edge length sizes.
- If you aren't able to do this, open Task Manager and watch your memory when you are running the process in nTop. See if your memory hits its limit.
- If the memory is hitting its limit: Make sure your hardware matches the minimum system requirements: nTop System and Licensing Requirements Guide. If it doesn't, it may need to be upgraded in order to optimally run nTop.
- If the memory isn't hitting its limit, contact Support.
If you still need assistance, reach out to Support and we will assist you.